How to install high pressure blower and how to use
Time: 2018-12-03 10:43 Browse:
First of all, when we install the high-pressure fan on the platform, we must use screws to fix it on a level and relatively rigid foundation. The basic weight is generally about 3 times the standard of the fan. If the machine base is uneven, then when the screws are tightened, the base of the high-pressure blower may be deformed, which affects the operation, so special attention should be paid;
Shock absorbers (or pads) can be added to reduce noise. Secondly, the high-pressure fan is usually designed such that the shaft is horizontal. When the suction port is used upward or downward, the weight of the impeller and the sub-shaft is added to the bearing on one side, which increases the load and reduces the bearing life. For the use of vertical places, please contact Meiqile Electromechanical Company first.
。 In addition, when the suction port is not connected with a ventilation pipe, in order to prevent foreign matter from being drawn in, please install a wire mesh screen or use a dedicated fan filter
. The fan should be at least 20mm away from the wall, so that the cooling air can flow smoothly.
When installing the pipe, the pipe can be screwed directly to the blower, so that the center is as consistent as possible, and the connection cannot be forced. The weight of the pipe should not be directly applied to the blower, especially the iron pipe. A bracket top frame needs to be installed to prevent the weight from being concentrated on the air outlet pipe for a long time to cause damage.
。 Avoid sudden shrinkage, expansion, or bending of high-pressure blower pipes to avoid poor fluid efficiency. For details, see: How high-pressure blowers work with pipes
. When the gas to be pumped contains dust or particulate matter, a suitable air inlet filter should be installed at the entrance of the Dongfeng high pressure blower to prevent particulate matter from being sucked into the cavity of the high pressure blower to damage the blades, expand the loss, and install the filter. Does not affect gas in and out.
The pipeline of the high-pressure blower and the pumped container should be clean, dry and leak-free. The diameter of the pipeline should not be less than the inlet of the high-pressure blower, and the length should not be too long to reduce suction loss. There should be no leakage at the pipe connection.
When wiring high-pressure fans, you must install a ground wire and confirm the running direction. The direction of operation is indicated by the arrow on the wind.